Marking horizontal line
Using the same technology as manufactured stone veneer, Geopietra® , has produced a select range of brick slips. This solution is complete with models in natural version chosen in the best brick factories in Northern Europe. Individual models from popular areas are still produced with manual procedures, cut to a thickness of 25 mm from solid pieces.
Calculate joint thickness to obtain whole multiples to be distributed over the height of the wall.
Mark out horizontal lines equivalent to the sum of the brick height and the corresponding joint (or its multiples). Keep courses in line with a straight edge and level.
Model-specific information is outlined below to speed up the operation:
The brick covering can be installed from the bottom upwards or vice versa, as thanks to Geocoll® there are no issues with slippage. Corners should be installed first at the beginning of each course, alternating long and short sides.
